Call Forwarding Parameters

The call forwarding parameters are described in the table below.

Call Forwarding Parameters

Parameter

Description

'Enable Call Forward'

configure voip > gateway dtmf-supp-service supp-service-settings > call-forward

[EnableForward]

Enables call forwarding.

■ [0] Check box cleared o = Disabled.
■ [1] Check box selected þ = (Default) Enabled.

For FXS interfaces: You must configure the Call Forward table (FwdInfo parameter) to use the Call Forward feature (see Configuring Call Forward. The device uses SIP 302 (Moved Temporarily) responses for call forwarding.

Note:

■ To use this service, the devices at both ends must support call forwarding.
■ For the device to respond to SIP 3xx responses with a new SIP request (forwarding the original request), enable the parameter.

Call Forward Reminder Ring Parameters

Note:

■ These parameters are applicable only to FXS interfaces.
■ For a description of this feature, see Call Forward Reminder Ring.

'Enable NRT Subscription'

configure voip > gateway dtmf-supp-service supp-service-settings > nrt-subscription

[EnableNRTSubscription]

Enables endpoint subscription for Ring reminder event notification feature.

■ [0] Check box cleared = (Default) Disabled
■ [1] Check box selected = Enable d

'AS Subscribe IP Group Name'

configure voip > gateway dtmf-supp-service supp-service-settings > as-subs-ipgroupname

[ASSubscribeIPGroupName]

Defines the IP Group (by name) that represents the Application server for Subscription.

'NRT Subscribe Retry Time'

configure voip > gateway dtmf-supp-service supp-service-settings > nrt-sub-retry-time

[NRTSubscribeRetryTime]

Defines the Retry period (in seconds) for Dialog subscription if a previous request failed.

The valid value range is 10 to 7200. The default is 120.

'Call Forward Ring Tone ID'

configure voip > gateway dtmf-supp-service supp-service-settings > cfe-ring-tone-id

[CallForwardRingToneID]

Defines the ringing tone type played when call forward notification is accepted.

The valid value range is 1 to 5. The default is 1.